Support Articles

If you plan on using a LIT-10 battery pack, please follow these instructions:

1. To avoid any problems, you must activate the camera using AA batteries.
2. Then power ON the camera to complete at least one sync with the servers.
3. Charge the LIT-10 using the supplied cable.
4. Power OFF the camera and take out the AA batteries.
5. Insert the LIT-10 battery, change the battery setting within the SPYPOINT app to LIT-10 and ensure the transfer frequency is at each detection.
6. Power ON the camera and complete another sync with the servers to save the battery setting into the camera and wait for ALL camera lights to turn off.
7. Wave your hand in front of the camera to trigger a photo. The status light should illuminate green and then orange showing that the photo is being sent to you.
8. After confirming that you have received the photo – check the status page from the app. The battery level should now indicate LIT-10 with the % of battery remaining.